MAX1186ECM+D

The MAX1186ECM+D is a dual 10bit, 40Msps, 3V low power ADC with internal reference and multiplexed parallel outputs in 48 pin TQFP package. It features fully differential wideband track and hold (T/H) inputs driving two pipelined nine-stage ADC. It consumes only 105mW while delivering a typical signal to noise ratio (SNR) of 59.4dB at an input frequency of 20MHz and a sampling rate of 40Msps. Digital outputs A and B are updated alternating on the rising (CHA) and falling (CHB) edge of the clock. The T/H driven input stages incorporate 400MHz (-3dB) input amplifiers. The converter may also be operated with single ended inputs. In addition to low operating power, IC features a 2.8mA sleep mode as well as a 1µA power-down mode to conserve power during idle periods. It is used in multichannel IF sampling, I/Q channel digitization, ultrasound & instrumentation.

• Supply voltage range is 2.7V to 3.6V
• Operating temperature range from -40°C to 85°C
• Excellent dynamic performance, 59.4dB SNR at fIN = 20MHz & 72dBc SFDR at fIN = 20MHz
• Low power supply current of 35mA (normal operation), 2.8mA (sleep mode) & 1µA (shutdown mode)
• 0.02dB gain and 0.25° phase matching, 400MHz of -3dB input bandwidth
• Wide ±1Vp-p differential analogue input voltage range
• On-chip 2.048V precision band gap reference
• Single 10bit bus for multiplexed, digital outputs
• Parallel, multiplexed, CMOS compatible three-state outputs
• User-selectable output format - two’s complement or offset binary

Področja uporabe

Signal Processing, Industrial, Imaging, Video & Vision

Opombe

ADI products are only authorized (and sold) for use by the customer and are not to be resold or otherwise passed on to any third party