V spodaj označena polja ste vnesli vrednosti z neveljavnimi znaki. Prilagodite izbiro tako, da bo vsebovala samo veljavne znake.

Izdelek se morda ne ujema popolnoma z vašim iskanjem

Ta izdelek ste že kupili. Oglejte si zgodovino naročil

 
 

FT245RQ-REEL

Interface Bridges, USB to FIFO, 1.8 V, 5.25 V, QFN, 32 Pins, -40 °C

Date/Lot Code
FTDI FT245RQ-REEL
×
×

Slika je zgolj simbolična. Oglejte si opis izdelka.

Proizvajalec:
FTDI FTDI
Proizvajalčeva št. dela:
FT245RQ-REEL
Številka naročila:
1146035RL
tehnični podatkovni list:
FT245RQ-REEL   Datasheet
Oglejte si vse tehnične dokumente

Pregled izdelka

The FT245RQ is an USB to parallel FIFO Interface IC, simplifies USB to FIFO designs and reduces external component count by fully integrating an external EEPROM, USB termination resistors and an integrated clock circuit which requires no external crystal, into the device. It has been designed to operate efficiently with a USB host controller by using as little as possible of the total USB bandwidth available. The USB to parallel FIFO interface integrated circuit with the new FTDIChip-ID™ security dongle feature. In addition, asynchronous and synchronous bit bang interface modes are available. USB to parallel designs using the IC have been further simplified by fully integrating the external EEPROM, clock circuit and USB resistors onto the device. The IC adds a new function compared with its predecessors, effectively making it a 2-in-1 chip for some application areas. A unique number is burnt into the device during manufacture and is readable over USB.
  • Single chip USB to parallel FIFO bidirectional data transfer interface
  • Entire USB protocol handled on chip, no USB-specific firmware programming required
  • Simple interface to MCU/PLD/FPGA logic with simple 4-wire handshake interface
  • Data transfer rate to 1Mbps D2XX direct drivers
  • Data transfer rate to 300kbps VCP drivers
  • FTDI's royalty-free virtual com port (VCP) and direct (D2XX) drivers
  • New USB FTDIChip-ID™
  • FIFO receive and transmit buffers for high data throughput
  • 256-byte receive buffer and 128-byte transmit buffer utilising buffer smoothing technology
  • Adjustable receive buffer timeout
  • Synchronous and asynchronous bit bang mode interface options with RD# and WR# strobes
  • Integrated 1024-bit internal EEPROM for storing USB VID, PID, serial number/product desc. strings
  • Device supplied pre-programmed with unique USB serial number
  • Support for USB suspend/resume through PWREN# pin and wake up pin function
  • In-built support for event characters
  • Support for bus powered, self powered and high-power bus powered USB configurations
  • Integrated 3.3V level converter for USB I/O
  • Integrated level converter on FIFO interface and control pins for interfacing to 5 to 1.8V logic
  • True 5/3.3/2.8/1.8V CMOS drive output and TTL input
  • High I/O pin output drive option

Področja uporabe

Computers & Computer Peripherals, Consumer Electronics, Sensing & Instrumentation, Industrial, Automation & Process Control

Sprotne opombe

Market demand for this product has caused an extension in leadtimes. Delivery dates may fluctuate. Product exempt from discounts.

INFORMACIJE O IZDELKU


Poiščite podobne izdelke Izberite in spremenite zgornje lastnosti, da boste našli podobne izdelke.

Tehnični dokumenti (2)

Prevzemi datotek CAD

×

Pogoji in določila

CAD Models - Notice
CAD Models and drawings are provided to you on a revocable limited licence for your internal use only but remain the property of the manufacturer who retain all intellectual property rights and ownership. They are provided to assist you in decision making and as design guide but are not guaranteed to be error free, accurate or up to date and is not intended to be taken as advice.
Use of these CAD models and other options provided are downloaded and used entirely at your own risk and by continuing you confirm acceptance of the above.

Sprejmi Prekliči
Vrsta pakiranja Ponovno navitje
Za ta izdelek bo prištet strošek ponovnega navijanja v višini € 5,00"
 
Na voljo dodatne možnosti pakiranja
Narezan trak :1146035 Preveri zaloge

Na voljo za prednaročilo

Dostave se začnejo od 2.3.2023

Zaradi razmer na trgu so navedeni časi dostave navedeni le kot splošna smernica in so lahko predmet spremembe v zelo kratkem času.

Obvestite me, ko bo izdelek spet na zalogi.

€ 5,10

Cena ni na voljo. Obrnite se na pomoč kupcem.

Cena za:
kos (dobavljen na prirezanem traku)
Več: 1 Najmanj: 100
Količina Cena Vaša cena
 
 
100+ € 5,10
Promocijska cena
Pogodbena cena
Cena za spletni nakup
Pogodbena cena za spletni nakup
 
 
 

Cena ni na voljo. Obrnite se na pomoč kupcem.

No longer stocked:: No Longer Manufactured::
Dodaj v košarico Dodaj v košarico Prednaročilo
Dodaj
Izdelek z omejitvijo
Dodaj št. dela /opombo k postavki
Skupna cena:
Skupna cena: ( )
Skupna cena: --
100 (Narezan trak 1146035) x 5,1 = € 510
Skupna cena: € 510
Nekateri ali vsi naročeni izdelki bodo med neizpolnjenimi naročili. Za podrobnosti si oglejte povezavo Preveri zaloge in dobavne roke.
100 (Ponovno navitje 1146035RL) x 5,1 = € 510
Skupna cena: € 510
Nekateri ali vsi naročeni izdelki bodo med neizpolnjenimi naročili. Za podrobnosti si oglejte povezavo Preveri zaloge in dobavne roke.
Izberite želeno pakiranje
1146035
*Opomba: Če izberete izdelek za ponovno navijanje na kolut, se zaračuna € 5,00."
Ponovno navitje je kolut po meri, ki je na voljo za izdelke na narezanem traku, kadar je količina naročila višja od 100
Opomba: drugače pakirane pošiljke so lahko odposlane iz oddaljenih skladišč. Oglejte si informacije o dostavi in dobavnem roku za posamezne možnosti pakiranja.